4 channel relay modules
Item No.: ST1097
Module parameters:
1. Size: 75 mm (length) * 55 mm (width) * 19.3 mm (high)
2. Weight: 61 g
3. PCB color: Red
4. The board with four fixed screw holes all round, hole diameter is 3.1 mm, convenient installation and fixed
5. Loose relay, relay selection of quality single pole double throw. A common end and a beginning, a normally closed end
6. Optical coupling isolation, anti-interference performance is good
7. Low level off, released in high level. Suction state indicator right, release the state when the light is out
8. VCC for system power, JD_VCC power supply for the relays. The default 5 v relay, with jumper cap
9. Maximum output relay: 30 v / 10 a dc, ac 250 v / 10 a
Voltages 2023-06-05 02:32:18
Jesus Christ, document the shit you sell.
Voltages 2023-06-05 02:32:14
Jesus Christ, document the shit you sell.
Comment
Recommended Products
-
ESP8266 Wifi Shield For ArduinoItem No.: AD010 -
2×16 LCD ControllerItem No.: ST1113 -
Stepper Motor Controller ModuleItem No.: ST1112 -
SIM900A GPRS/GSM ShieldItem No.: AD046 -
NANO 3.0 Controller TerminalItem No.: EX015 -
L293D Servo and Motor Controller ModuleItem No.: ST1138 -
Ethernet Interface ModuleItem No.: ST1160 -
PIR Motion Detector ModuleItem No.: SE062 -
8×8 Dot matrix drive ModuleItem No.: ST1156 -
Joystick Controller ModuleItem No.: ST1124 -
Sensor Expansion shield V4.0Item No.: ST1035 -
5V 8 Channel Relay Module Board for ArduinoItem No.: ME115 -
Data Log ModuleItem No.: ST1046 -
4× 5050 RGB LED ModuleItem No.: ME141 -
Ethernet W5100 R3 Shield Network BoardItem No.: ST1044 -
8×8 Full-color RGB LED Matrix Driver ModuleItem No.: ST1149
