8bit 5050 Full color RGB LED module

Interface:
• VCC: connect to DC5V • G: connect to GND • DI: connect to data input • DO: connect to data output
Features of single LED:
anti-reverse protection circuit, the reverse of power supply will not damage the internal IC of the LED. IC control circuit and LED point light source uses
the same power supply.
control circuit and the RGB chip are integrated in a 5050 SMD component, forming a complete control of pixel point. Built-in signal reshaping circuit,
signals received will be wave-reshaped first and then output to the next driver, ensuring wave-form distortion to not accumulate. Built-in power on
reset circuit and power-down reset circuit.Each pixel of the three primary color can achieve256 brightness display, completed 16777216 color full color
display, scan frequency no less than 400Hz/s
Serial cascade interface, via a signal line to complete the reception and decoding of data.
When transmission distance between two arbitrary points is no more than five meters, no extra circuit needed. When the refresh rate is 30fps, cascade
number no less than 1024 points. Data sending speed can reach 800Kbps.The color of the light is highly consistent, cost-effective.
Advantages:
1. LED with built-in IC is brighter than common LED 2. High consistency of RGB chips for all LEDs 3. Reliable performance of built-in driver IC
4. Use hard plastic for packaging, prevent press damage 5. Relatively low cost with quality ensured