LilyPad Coin Cell Battery Holder
Item No.: ME203
This LilyPad Coin Cell Battery Holder has a small slide switch installed on the board, in-line with the power so you can shut off your project and save
batteries. This slide switch is the same as is found on the LilyPad slide switch board, so it’s not easy to accidentally turn off or on.
Just like the original Coin Cell Battery Holder, this simple board holds a 20mm coin cell battery (such as a CR2032) and gives you 4 connection points
(two positive and two negative) for sewing into your project.
batteries. This slide switch is the same as is found on the LilyPad slide switch board, so it’s not easy to accidentally turn off or on.
Just like the original Coin Cell Battery Holder, this simple board holds a 20mm coin cell battery (such as a CR2032) and gives you 4 connection points
(two positive and two negative) for sewing into your project.
Comment
Recommended Products
-
Dual ultrasonic sensorItem No.: ST1099 -
37 in 1 Sensor Kit For ArduinoItem No.: ST1065 -
FTDI Basic Program Downloader USB to TTL FT232 for ArduinoItem No.: ST1125 -
Stepper Motor Controller ModuleItem No.: ST1112 -
NANO 3.0 Controller TerminalItem No.: EX015 -
RF Transceiver ModuleItem No.: ME019 -
L293D Servo and Motor Controller ModuleItem No.: ST1138 -
lithium battery charger boardItem No.: ME058 -
PIR Motion Detector ModuleItem No.: SE062 -
8×8 Dot matrix drive ModuleItem No.: ST1156 -
A4988 Stepper Motor Driver ModuleItem No.: 3DS051 -
Smart home kit based on IDUINOItem No.: KST036 -
Bluetooth transmission moduleItem No.: ME081 -
5V 2 Channel Relay Module ShieldItem No.: ME114 -
5V Relay BoardItem No.: ST1080 -
5V 8 Channel Relay Module Board for ArduinoItem No.: ME115